Cunningham Penile Incontinence Clamp

This product is not a medical cure and is not intended to replace medical advice. Always consult a physician before use. Individual results may vary.”

Designed to assist in managing urinary leakage for men with mild to moderate bladder challenges. 

Many users report reduced leakage and comfort during day-to-day activities. Results may vary, always consult your healthcare provider.

Manufactured by Bard, this Penis Clamp offers effective incontinence control in lieu of wearing adult diapers.

Bard Cunningham Incontinence Clamp is a hinged, stainless steel frame supporting two foam rubber pads and a locking device. The user places the penis between the two foam pads and the hinged is squeezed shut. The lower foam pad has an inverted "V" which presses against the underside of the penis exerting a closing pressure on the urethra, which is close to the underside of the penis. The ratchet locking clamping mechanism has five separate settings to control male incontinence. This permits the user to achieve the proper amount of pressure to prevent urine leakage without discomfort.

Features

• Reusable and washable
• Adjustable fitting
• May help reduce leakage associated with stress incontinence or bed wetting
• Suitable for use with males of all ages

Specifications

• Product Numbers: 004052, 004053, 004054
• Size Options: Juvenile, Regular or Large
• Sizes:1 - (1-1/2 inch), Size 2 - (2 inch) or Size 3 - (3 inch).
• Materials: Steel, foam and latex
• Application: Control stress incontinence
• Non-sterile
• Replace every 3 months or when there are signs of deterioration, cracking, discoloration or separation of foam
• Manufacturer: Bard Medical

Product Sizing

Product Sizing is by penis shaft circumference, not length. Three sizes are available--large, regular or juvenile. Most men use the size 2. Below is a guide to help you to select the best clamp size to meet your needs.

• Step 1: measure the circumference of your penis with a tape measure.
• Step 2: select the size that best meets your circumference measurement.
  • If your circumference measurement is 3 inches or more, select the large clamp.
  • If your circumference measurement is around 2 inches, select the regular clamp.
  • If your circumference measurement is around 1-1/2 inches, select the juvenile clamp.

How to Properly Apply

• Step 1: Place the clamp about halfway down the shaft of your penis between the two foam pads.
• Step 2: Tighten the clamp to compress your urethra. Use the ratchet catch to adjust the pressure. This is what stops urine flow. The large and regular clamps each have 5 settings that adjust the pressure on your urethra. To release the catch, press inward on both of the spring wire loops. The juvenile clamp is not adjustable.
• Step 3: Loosen your clamp every 1 to 2 hours to allow urine to flow. Going beyond 2 hours places you at higher risk of contracting a urinary tract infection. Reposition the clamp slightly up or down the shaft or you penis so that it is not in the same place as before.
  
• Step 4: Ensure that the clamp is not set too tightly, cutting off blood circulation or causing skin irritation.

Important Safety Information: Use only as instructed. Do not wear continuously for over 2 hours without relaxing. Not intended for overnight use. Consult a medical professional if you experience discomfort.

Cleaning Tips and Tricks

1. Wash in a sink with mild soapy water.
2. Rinse thoroughly with clean water.
3. Gently squeeze the foam to get rid of excess water.
4. Air dry at room temperature away from excess heat or direct sunlight.
5. Do not use bleach, detergent, or hot water on your clamp.
6. Do not put in the washer or dryer
7. Do not use a blow dryer on the clamp.

Notes

Many incontinence clamp users keep three serviceable urine clamps on-hand at any given time. They rotate between two of the clamps daily and keep one as a spare. Rotating the clamp daily allows the foam pads to reposition fully before each use.